3-104 FUEL SYSTEM (DFI)
Indicator Unit Connector [A]
Ignition Switch Connector [B]
Ignition Switch [C] and Screws [D]
Bracket [E] and Bolt [F]
Remove the seat (see Frame chapter).
Disconnect the battery (−) terminal [A].
Open the fuel pump lead clamp [B].
Raise the lock [C] and disconnect the fuel pump connector
[D] (black, 4p).
The fuel pump connector has fuel pump leads and fuel
reserve switch leads.
Remove the breather hose [E] and fuel tank bolt [F].
Prepare rubber hoses of the inside diameter 5
(e.g. Rubber Tube: Part No. 92191-1272) × L about 80
mm and make plug hoses [A] of the rubber hose with one
end tied with a wire [B].
Raise the rear of the tank up, and disconnect the hoses
on the bottom.
Plug these pipes [C] with two plug hoses to prevent fuel
While lifting the rear of the tank up, stuff a clean shop
towel around the fuel return fuel hose [A] so that the fuel
doesn't leak onto the engine top (rear view).
Slide down the clamp [B] and pull the fuel return hose off
the fuel inlet pipe of the fuel tank.