Throttle Body Assy
Remove the decelerator cable end [A] from the throttle
Using needle nose pliers, move the accelerator inner ca-
ble outside the engine, and remove the cable end [C] from
Pinch the lock of the fuel hose joint #2 [A] with your fin-
gers, pull the joint #2 out along the pipe (for delivery joint),
and take out the fuel hose assy [B].
Remove the oil hose clamps [A].
Unscrew the inlet manifold bolts [B].
Inlet Manifold [C]
Pull the vacuum hoses [C] off the pressure regulator [A]
and the throttle body [B] (rear view).
Take out the throttle body assy [A] from the right side,
while tilting it up.
Be careful not to damage (dent, nick, flaw, and crack) the
flange mating surface and the plastic parts.
Do not drop the throttle assy, especially on a hard surface.
The throttle body assy should never be allowed to
fall. Throttle may become stuck, possibly causing
FUEL SYSTEM (DFI) 3-95