3-94 FUEL SYSTEM (DFI)
Throttle Body Assy
Remove the following from the choke cable holder [A] (left
Choke Cable Plate [C]
While pushing the choke lever [A] forward, remove the
cable housing from the choke cable holder [B] and the
inner cable out of the holder slit [C].
Take off the lower end [D] from the choke lever.
Remove the screws and take off the right switch housing.
Remove the accelerator cable end [A] and decelerator
cable end [B] at the throttle grip.
Pry open the staking [C] on the throttle cable holder [E],
and remove the cable clip [D].
Rear View [F]
Accelerator Cable [A] and Decelerator Cable [B]
Do not remove the throttle cable holder.
holder is damaged, replace it along with the throttle
Turn the throttle pulley [A] as shown, and pull out the ac-
celerator cable housing [B] from the cable holder [C] (rear
Return the pulley, and pull out the decelerator cable hous-
ing [D] from the cable holder.