Fuel Injectors (#1, #2: Service Code 41, 42)
Apply engine oil to the O-ring [A], and install each injector
[B] into the delivery joint [C].
Check that there is no dirt or dust on the injector seating
surface [A] of the inlet manifold [B].
Check that the two dowel pins are in place in the inlet
Fit the end of the injector into the delivery joint [C], and
install them along with the joint screws [D], and the screw
collar [E] onto the inlet manifold.
Fit [F] the tip of the injector evenly into the inlet manifold.
Torque - Delivery Joint Screws: 3.4 N·m (0.35 kgf·m, 30
Pressure Regulator Screws: 4.9 N·m (0.50 kgf·m,
FUEL SYSTEM (DFI) 3-67