Black & Decker BRVA425B00 Manual page 9

Activate the Robot
Place robot onto the Charging Dock, making sure the metal charging
Charging Dock match up with those underneath the Robot.
If successful you will hear a series of tones. once the
robot is ready for use.
Start Cleaning Cycle
• Press the power button Once to wake up the Robot.
• Press the power button again to start a cleaning cycle.
If its battery gets low before finishing a cleaning cycle, Robot will return to the Charging Dock
to recharge.
lf the Charging Dock is inaccessible, Robot will not be able to recharge. It will return to its
starting location and the cleaning cycle will end. Place the Robot manually on
Charging Dock for charging. (Refer Activate the Robot)
Pause
• To pause the Robot during a cleaning cycle press the
button on Remote Control.
• To resume the cleaning cycle, press
• To send robot back to The Charging Dock, press
Note: The actions listed above can also be managed from the Remote Control.
8
Power OFF
• Turn off the main power switch on the bottom of robot.
2.2 Robot Cleaing Operation
Auto Cleaning
• At the start of a cleaning cycle, Robot will map out your home and cleaning
it efficiently.
• The Robot has the ability to clean around all edges and in-between and around
chair legs and furniture.
• Robot continues this process until it has cleaned entire level of your home.
If its battery gets low before finishing a cleaning cycle, Robot auto ret urns to
the Charging Dock to recharge.
• Once Robot finishes its cleaning cycle, it will return to the
recharge.
Wet Mop Feature
Robot supply a water tank that the robot can floor
mops Cleaning for your home
1. Attach the cloth and fill in the water tank with water.
2. Remove the dust bin.
3. Put back the water tank to robot and start the Robot.
Note: This is not necessary if you are only using dry clean mode.
08
contacts on the
Power button illuminates
but ton or press the
button again.
button.
Charging Dock to
(Original instructions) ENGLISH
9