Frequently Asked Questions - Black & Decker Brva425B00 Manual

Frequently asked questions

Problems
Robot
cannot be activated.
The remote control does not work.
Robot
stops working suddenly.
You can't schedule cleaning.
Suction power is weak.
Robot can't be charged.
Robot can't return to the Charging Dock.
The rolling brush doesn't rotate.
Robot movements or travel path are abnormal.
14
(Original instructions)
Solutions
• Make sure the main power switch is in the ON position.
• Make sure the battery is fully charged.
• Replace the batteries (2 AAA) in the Remote Control.
• Make sure the remote control is within range (16 ft/5 m) of robot.
• If you still have trouble, turn off the main power switch
and then turn it back on.
• Replace the batteries in the Remote Control.
• Make sure robot is turned on and fully charged.
• Check if robot is trapped or stuck on an obstacle.
• Check if the battery level is too low.
• If you still have trouble, turn off the main power.
switch, wait for 2 seconds, and then turn it back on.
• Make sure the main power switch on the bottom of robot is turned on.
• Make sure the time, time of day (AM/PM), and the scheduled time have
been set correctly.
• Check if robot's power is too low to start cleaning.
• Check if any obstructions are blocking the suction inlet.
• Empty the dust bin.
• Clean the filters with a vacuum cleaner or a cleaning brush.
• Check if the filters are wet due to water or other liquid on the floor.
Air-dry the filters completely before use.
• Check if the indicator on the Charging Dock lights up. If not, contact the
service center to repair or replace the Charging Dock.
• Dust off the charging contact pins with a dry cloth.
• Check if you can hear a beep when robot is return the Charging
Dock. If not, contact the service center to repair or replace the
Charging Dock.
• Remove objects within 3 ft/1 m to the left and right side and within 6
ft/2 m of the front of the Charging Base.
• When robot is in the vicinity of the Charging Dock, it will return more
quickly. However, if the Charging Dock is located far away, Robot will
need more time to return. Please be patient as it works its way back.
• Clean the charging contact pins.
• Clean the Rolling Brush.
• Check if the Rolling Brush and brush guard have been installed properly.
• Clean the sensors carefully with a dry cloth.
• Restart robot by turning the power switch off and on.
ENGLISH
15