Advertisement
Quick Links
This quick start guide provides first time setup instructions and other useful instructions
for the epoc® Host² (Zebra MC55A0, MC55X).
For complete user instructions, please refer to the epoc System Manual, available at
siemens-healthineers.com/document-library.
epoc Host2 Components
Barcode Scan LED
Barcode scanning active
Successful scan/capture (blinking)
Barcode
scanner
Scan Button(s)
Power Button
Rev.: 17
siemens-healthineers.com/eifu
epoc Blood Analysis System
epoc Host2 Quick Start Guide
Manufactured by:
Epocal Inc.
2060 Walkley Rd.
Ottawa, ON K1G 3P5 Canada
siemens-healthineers.com/epoc
Charging/Battery LED
Battery fully charged
Battery charging (blinking)
Charging error (fast blink)
Radio Status LED
(NOT USED!)
Scan Button
Touch Screen
Keypad
Cradle Blade
Authorized Representative:
Siemens Healthcare Diagnostics
Manufacturing Ltd.
Chapel Lane
Swords, Co. Dublin, Ireland
siemens-healthineers.com/poc
51005527-EN Rev.: 17 2023-04
Advertisement
Related Manuals for epoc Host2
Summary of Contents for epoc Host2
- Page 1 Host2 Quick Start Guide This quick start guide provides first time setup instructions and other useful instructions for the epoc® Host² (Zebra MC55A0, MC55X). For complete user instructions, please refer to the epoc System Manual, available at siemens-healthineers.com/document-library. epoc Host2 Components...
- Page 2 Before using the epoc Host2, charge its battery as follows: 1. Connect the epoc Reader power supply to the power jack on the back of the Reader. 2. Insert the epoc Host2 into the epoc Reader’s pivot slot as shown. The initial charge will take approximately eight hours.
- Page 3 IT departments may use MAC address filtering to block unwanted device access to the network. 1. Run Zebra Wireless Fusion. • Turn on the epoc Host2 by pressing the Power button. • At the login screen, scan or enter the word “administrator” into the User ID and Password fields.
-
Page 4: Step 3: Connect To Your Wi-Fi Network
From the Wireless Status menu, tap 3) IPv4 Status. The MAC address will be displayed. Note: Alternatively, you can obtain MAC address while logged in the epoc Host application by going to Help, About. For MAC address to be displayed on the About screen, you must have a profile created and connected in Zebra Wireless Fusion and DM Present? set up to Yes in DM Options. - Page 5 For networks that DO NOT broadcast their SSID: • Tap the Fusion on-screen icon and select Manage Profiles from the menu. • Proceed to “Configure the Wi-Fi Network Profile” as described below. You will need to enter your settings manually. Configure the Wi-Fi Network Profile.
- Page 6 Step 4: Connect to the data manager Configure data management options • Turn on the epoc Host2 by pressing the Power button. • Log in to the epoc Host application as administrator (see above). • Once you are logged in, select Tools, then Options, then DM Options from the menu.
- Page 7 How to reset the epoc Host There are two reset functions – warm reset and cold reset. In the rare event that the epoc Host2 stops responding or is not functioning properly, perform a warm reset. If the epoc Host2 still does not respond, perform a cold reset.
- Page 8 How to install or replace the microSD Card on the epoc Host2 The SD card slot is located on the back of the epoc Host2 under the battery compartment. Note: It is not necessary to remove the plastic cradle. Battery Latch 1.
Need help?
Do you have a question about the Host2 and is the answer not in the manual?
Questions and answers