Electrical Safety; Installing The Batteries - Black & Decker Bxff53001Gb Original Instructions Manual

ENGLISH (Original instructions)

Electrical safety

Before use, check that the mains voltage
corresponds to the voltage on the rating plate.
Always check that the mains voltage
corresponds to the voltage on the rating
plate.
♦
Appliance plugs must match the outlet. Never
modify the plug in any way.
♦
Do not use any adapter plugs with this appliance.
Unmodified plugs and matching outlets will reduce
the risk of electric shock.
♦
To avoid the risk of electric shock, do not immerse
the cord, plug or appliance in water or other liquid.
Extension cables & class 2 product
♦
A 2 core cable must be used as your tool is not
earthed.
♦
Up to 30m (100 ft) can be used without loss of
power.
♦
If the supply cord is damaged, it must be
replaced by the manufacturer or an authorised
BLACK+DECKER Service Centre in order to avoid
a hazard.
Warning!
Before assembling, switch the appliance
off and remove the plug from the socket.
Features (Refer to diagram on page 2)
Carry Handle
1.
Remote Control (back of unit)
2.
Control Panel
3.
Front Grille
4.
Blade
5.
Tilt Axis
6.
Rear Grille
7.
Base
8.
6
Use
About the Controls
♦
3 Speed Settings
♦
7 Hour Timer
Remote Control
ON / OFF
Fan speed
Timer

Installing the Batteries

WARNING: Battery acid leakage can cause
personal injury and cause damage to the product
and surrounding property. If battery leakage occurs,
thoroughly wash any affected skin, making sure to
keep battery acid away from eyes, ears, nose and
mouth. Immediately wash any clothing or other
surface that comes in contact with leaked battery
acid. If a chemical burn occurs or if irritation persists,
seek medical attention. Dispose according to Local,
State or Federal regulations.
WARNING: NEVER mix old and new batteries or
different brands of batteries. Replace all batteries at
the same time.
NEVER mix alkaline, standard (carbon-zinc),
rechargeable (nickel-cadmium) batteries with this
product.
NEVER dispose of batteries in fire, as they may leak
and explode.
ALWAYS remove exhausted batteries from product.
Batteries are to be inserted following the polarity
markings on the product.
Remove batteries before extended storage.
♦
To begin using your fan, start by installing the
batteries.
♦
To install the batteries, first detach the battery
cover from the remote. To do this, place a thumb
or small object on the grooved area at the top of
the battery cover and push it gently downwards
and away from the body of the remote.