Bluetooth; Remote Control - Yamaha RX-A800 Owner's Manual

Yamaha rx-a800: user guide
Hide thumbs Also See for RX-A800:
Table of Contents

Advertisement

Bluetooth™

Display
Cause
Searching...
The Yamaha Bluetooth wireless
audio receiver and the Bluetooth
component are in the process of
pairing.
The Yamaha Bluetooth wireless
audio receiver and the Bluetooth
component are in the process of
establishing a connection.
Completed
The pairing is completed.
Canceled
The pairing is canceled.
BT connected
The connection between the
Yamaha Bluetooth wireless audio
receiver and the Bluetooth
component is established.
Disconnected
The Bluetooth component is
disconnected from the Yamaha
Bluetooth wireless audio receiver.
Not found
The Bluetooth component is not
found.
Pairing may not have been
achieved.
See
Remedy
page
During pairing:
– pairing must be performed on the
Bluetooth component and this unit
simultaneously. Check if the Bluetooth
component is in pairing mode.
During connecting:
– check if the Bluetooth component is
turned on.
– check if the Bluetooth component is
within 32 ft. (10 m) of the Yamaha
Bluetooth wireless audio receiver.
Try pairing again.
76

Remote control

Problem
Cause
The remote control
Wrong distance or angle.
does not work or
function properly.
Direct sunlight or lighting (from
an inverter type of fluorescent
lamp, strobe light, etc.) is striking
the remote control sensor of this
unit.
The batteries are weak.
The remote control ID of the
remote control and this unit do not
match.
External components
The remote control code is not
cannot be controlled
correctly set.
using the remote
control.
Even if the remote control code is
correctly set, there are some
models that do not respond to the
remote control.
APPENDIX
Troubleshooting
See
Remedy
page
The remote control will function within a
maximum range of 20 ft. (6 m), and no
more than 30 degrees off-axis from the front
panel.
Adjust the lighting angle, or reposition this
unit.
Replace all batteries.
7
Match the remote control ID of this unit and
106
the remote control.
Set the remote control code correctly using
"Remote control code
search" on the CD-
ROM.
Try setting another code for the same
manufacturer using
"Remote control code
search" on the CD-ROM.
If this unit does not work when you press
Cursor B / C / D /
E, do the following.
When the key does not work during DVD
disc menu operation: press the
Input
selector
again.
When there is no response with remote
control operation of the OPTION menu/
Setup menu: press
SOURCE/RECEIVER
(it should glow orange) and try operating the
remote control again.
123
En

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents