ITS Telecom EKSELANS FA 6 AC User Manual

Ac 129 tr power supply

Advertisement

USER MANUAL
FA 6 AC
102020
AC 129 TR Power Supply
V01
ITS Partner O.B.S S.L · Av. Cerdanyola 79-81 Local C
08172 Sant Cugat del Vallés · Barcelona (Spain)
Phone: +34935839543 · info@ek.plus ·

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EKSELANS FA 6 AC and is the answer not in the manual?

Questions and answers

Summary of Contents for ITS Telecom EKSELANS FA 6 AC

  • Page 1 USER MANUAL FA 6 AC 102020 AC 129 TR Power Supply ITS Partner O.B.S S.L · Av. Cerdanyola 79-81 Local C 08172 Sant Cugat del Vallés · Barcelona (Spain) Phone: +34935839543 · info@ek.plus ·...
  • Page 2 USER MANUAL FA 6 AC NOTE: Photographs contained in this manual are for illustrative purposes only. These photographs may not match your installation. Products are subject to change through continuing improvements without prior notice. NOTE: Operator is cautioned to review and be fully aware of the drawings and illustrations contained in this manual before proceeding.
  • Page 3 USER MANUAL FA 6 AC INDICE OVERVIEW ........................................4 Safety Precautions ....................................4 Unpacking ........................................4 Pre-installation Inspection ................................4 Brief Introduction ....................................5 Outline Diagram ....................................6 Technical Specifications................................... 6 INSTALLATIONS ......................................7 Installation Notes ....................................7 Strand Mounting Installation ............................... 8 AC Output Connections ...................................
  • Page 4: Safety Precautions

    USER MANUAL FA 6 AC OVERVIEW Safety Precautions Read user manual carefully before proceeding with any part of the unit.  Read user manual carefully before proceeding with any part of the unit.  Installation and operation of the unit must be performed only by qualified personnel ...
  • Page 5: Brief Introduction

    USER MANUAL FA 6 AC damage. We are not responsible for damage caused by improper packaging on returned units. Brief Introduction FA series power supply is designed for powering signal processing equipment’s in cable networks and well known for its brilliant features: Toroidal linear transformer provides reliable performance and high efficiency.
  • Page 6: Outline Diagram

    USER MANUAL FA 6 AC Outline Diagram LED indicator 5/8 F type Toroidal transformer Input fuse Power cord w/plug Strand clamps Output disconnects EPI w/overloading protection Technical Specifications Table 1: Model Input V. Input Freq. Output V. Output Ic Max. Output Power FA 6 AC 220 Vac 50 Hz...
  • Page 7: Installation Notes

    USER MANUAL FA 6 AC Table 2: Input voltage range +/- 15% Power factor 0.90 at full load Output waveform Sine wave Output protection Current limited; 150% of max. current rating Efficiency >=85% Bandwidth 860MHz Flatness +/-0.5dB Insertion Loss 1.5dB (5MHz to 860MHz) Return Loss 14dB (5MHz to 860MHz) Finish...
  • Page 8: Ac Output Connections

    USER MANUAL FA 6 AC Strand Mounting Installation 1.- Loosen screws of fixing clips 2.- Split iron thread from the cable and let fixing clips through 3.- Finally, fasten fixing clips and check-up if installation is firm and reliable AC Output Connections Two 5/8”...
  • Page 9 USER MANUAL FA 6 AC position where the voltage required is present. Finally tighten seizure screws of the terminal block. A sketch is given below for reference. It may not match your installation. WARNING! Poor connection between cable/wire and the connectors may cause fire. ...
  • Page 10 USER MANUAL FA 6 AC EPI Operation w/o RF Input 1.- EIP operation w/ two AC OUT 2.- EIP operation w/ one AC OUT Note: It’s recommended to remove the disconnect of the output that is not used. Utility Power (AC Input) Connection If no specific requirements, input connection of FA non-standby power supply is made via a power cord with standard plug.
  • Page 11: Startup & Test

    USER MANUAL FA 6 AC supplier, supplier of the service disconnects and your local utility for specific installation instructions and guidelines. All electric codes apply. STARTUP & TEST Once connections and configurations are made, start-up and test may begin. All loads must be removed from the units before starting the test.

This manual is also suitable for:

102020

Table of Contents