Problem-Solving
Occasionally you may experience unexpected
results.
NOTE: This section discusses problems you may
experience when you have not applied
highlighting correctly.
Colors are not applied to all areas
Parts of the text or small areas may not reflect
highlighting even though Highlight is applied for
all areas. In this case, apply colors to the small
areas defined with Rectangle Area, then apply
colors to the areas within the boundary defined
with Point Whole Area. All the parts will be
colored.
Reason for problems
If the outline of an area is 0.5 mm of space or less,
the Edit Pad recognizes the lines as overlapping
lines instead of a boundary. Therefore, even if
Point Whole Area is selected, the area will not be
colored.
Key Procedure
1
Use Highlight on areas (parts surrounded by
approximately 0.5 mm of space or less) where
colors are missing. Select Highlight, then define
the area with Rectangle Area.
1.
Select Highlight, then select Rectangle
Area.
2.
Mark two points so that the text with a
width of 0.5 mm of space or less is
enclosed, then define the area.
3.
Select a color from the Color Palette.
EDIT PAD USER GUIDE
9-7
EDITING TIPS AND PROBLEM-SOLVING
9
3
4
6