Normal Sounds; Options - Whirlpool WFW9150WW Use And Care Manual

Normal Sounds

As with any new product, you will hear sounds that you are not
accustomed to. You may hear various sounds when the door is
locked or unlocked, and during the washing, rinsing, or spinning
process. Between changes in wash actions, there will be
momentary pauses. You will hear water spraying and splashing
during the wash and rinse cycles. These new sounds and pauses
are part of normal washer operation. See "Troubleshooting."
You can customize your wash by adding options to your cycle
selections. You can add or change an option after starting a cycle
anytime before the selected option begins. Not all Options are
available with all cycles.
■ See the "Laundry Guide" section for an overview of possible
options for each Wash Cycle selection.
■ If an option is available with a selected cycle, the light for that
option will illuminate when selected.
■ If an option is unavailable with a selected cycle, there will be a
short tone and the light for that option will not illuminate when
selected.
Extra Rinse
An extra rinse can be used to aid in the removal of detergent
residue from garments. This option provides an additional rinse
with the same water temperature as in the normal rinse. It is
automatic for the Whitest Whites cycle. You may select or
deselect by pressing EXTRA RINSE.
TUMBLEFRESH™ option
Use this option when you are not able to unload your clothes,
soon after the wash cycle ends. This option provides periodic
tumbling for up to 6 hours to help freshen your clothes. During this
time, the "Done" indicator remains activated, the door remains
locked, and the TUMBLEFRESH™ option indicator light will flash.
The TUMBLEFRESH™ option will automatically stop and the door
lock will be released after this time expires, or if you press POWER
at anytime to unload your laundry.
Delay Start
Use this to begin the wash cycle later.
■ Press DELAY START until the desired time (in hours) is
illuminated.
■ Press START/PAUSE. As the countdown is performed the
correct indicator will be illuminated.
16

Options

Temp
Each cycle has a preset water temperature setting. To change the
water temperature, press the TEMP button until the desired
setting is illuminated.
Select a water temperature based on the type of load you are
washing. Use the warmest wash water safe for fabrics. Follow
garment label instructions.
The water temperature for all rinses are cold. Cold rinses save
energy.
Temperature Guide
Temp
HOT
WARM
COLD
In wash water temperatures colder than 60°F (15.6°C), detergents
do not dissolve well. Soils may be difficult to remove.
Controlled Temperature
Warm and cold wash temperatures are sensed and maintained by
regulating the amount of hot and cold water from your faucet. This
provided excellent cleaning while saving energy.
ATC (Auto Temp Control) electronically senses and maintains a
uniform water temperature. ATC regulates incoming hot and cold
water.
■ Cold rinse is not controlled and will be the same as your cold
faucet.
Spin Speed
Each cycle has a preset spin speed. To change the spin speed,
press the SPIN SPEED button until the desired setting is
illuminated.
Signal On/Off
This signal is helpful when you are removing items from the
washer as soon as it stops. Press and hold SPIN SPEED button
for 3 seconds for Singal On or Signal Off.
Suggested Fabrics
Whites and pastels
Heavy soils
Bright colors
Moderate to light soils
Colors that bleed or fade
Light soils