Permobil Corpus 3G Assembly Instruction

Document type
Assembly Instruction
Document No. Revision
gggg gg
246355 A.00
Production state
ggggggg
Preform Date
ggggggg
2010-12-21
Mounting the Co-Pilot bracket on Corpus 3G
Order no.: 1825810
List of parts in the set.
1 pcs. Co-pilot bracket
4 pcs. screws ISO 4762 M6x12 Fe/Zn
Mounting
Read the instructions carefully before starting
installation.
1. Undo the stop screws holding the cover on the
back rest profile and remove the cover by sliding
it upwards along the groove. (Fig. 1)
2. Undo the screws on the bracket so that it is pos-
sible to slide the groove nuts down into the two
central grooves on the back rest profile. (Fig. 2)
3. Tighten the screws so that the groove nuts are
just under the top edge of the back rest profile.
NB! The bracket can be mounted lower, but
then the arm rest height needs to be adjusted.
4. Replace the cover on the back rest profile, and
check that the cover does not catch on any part
of the mounted bracket. Fix the cover in place
by tightening the stop screws.
Fig. 2. Slide the bracket's groove track nuts in.
Preform By Approved Date
ggg ggggggg ggg
UDN
Approved By
Co-pilot bracket C3G
2 pcs. groove nuts 2xM5 CC25
Fig. 1. Remove the cover.
Fig. 3. The bracket mounted.
Page
1