TP-Link TD-W8951NB Installation Manual page 2

Plug the provided Power Adapter into
the Power jack on the back of the Router
and the other end to a standard
electrical wall socket.
Power on all your network devices and then check to see if the LEDs of the
Router display normally as the diagram below describes.
Power: Solid light
ADSL: Solid light or flashing
WLAN: Solid light or flashing
LAN: Solid light if the corresponding
port is connected
If the LEDs display abnormally, please check to see if all the cable
Note
connectors (power adapter, phone line and Ethernet cable) are well
connected to your device. With the phone line well connected, if the ADSL
LED turns off after flashing, please contact your ISP to ensure that you r
internet connection is active.
To configure the device, you can either run the setup CD-ROM (method one),
Note
or run the Web based Quick Setup Wizard (method two). TP-LINK strongly
recommends that you run the setup CD-ROM.
2