HermanMiller Nevi Link 120 Installation Instruction

HermanMiller
Nevi Link 120 Installation Instruction
How to assemble your Nevi Link 120
Tools Required
Power Driver Phillips #2 Bit Phillips #3 Bit
Socket Wrench Kit
TorxBit Size: T30
(13 mm, 7/16")
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical furnishing, basic precautions should always be followed,
including the following:
Read all instructions before using this furnishing.
Please follow the initialization instructions, shown on the last page of this
instruction prior to using this furnishing.
DANGER
- To reduce the risk of electric shock always unplug this furnishing from
the electrical outlet before cleaning.
WARNING
- To reduce the risk of burns, fire, electric shock, or injury to persons:
Close supervision is necessary when this furnishing is used by, or near children,
invalids, or disabled persons.
Sitting or standing on product may cause risk of personal injury (use for chairs,
tables consider obvious misuse of product).
Use this furnishing only for its intended use as described in these instructions.
Do not use attachments not recommended by the manufacturer.
Never operate this furnishing if it has a damaged cord or plug, if it is not working
properly, if it has been dropped or damaged, or dropped into water. Return the
furnishing to a service center for examination and repair.
Failure to fully tighten screws (bolts) may cause injury by causing Nevi Link 120
tables to collapse. Unless otherwise specified, tighten screws (bolts) until they
stop plus a quarter turn.
HermanMiller
Square-Recess
Torque Wrench
Bit Size #2
Parts Included
Worksurface (3)
Leg Brace (3) 120 Connector (3)
120 Degree Top Cover Wire Trough (3)
T30 1/4-20 Thread M8 Hex Bolt Tapping Screw (6)
Forming Fastener (6) (12)
Shoulder M8 Lock Alignment
Screw (3) Nut (12) Screw (3)
Power Entry Junction Box
Power Entry
Periodically check to make sure legs are properly aligned. Failure to do so
may cause risk of personal injury.
If using power drive set on low torque.
Keep the cord away from heated surfaces.
Never drop or insert any object into any opening.
Do not use outdoors.
Do not operate where aerosol (spray) products are being used or where
oxygen is being administered.
This furnishing is intended for commercial use
control box rating: 5.0A, 120V
Duty cycle: 2 min on, 18 min off
1 1BN170 rev A
Leg (9) Stiffener (3)
120 Degree Bottom Cover
Leg Brace (3)
Side Electrical Electrical Top
Electrical Top
Cover (6) Tube (3)
Pan Head
Control Box (3)
Screw (34)
1/4-20 Lock
Top Tube Wire Clip (12)
Nut (12)
Screw (12)
Receptacle
Jumper
Assembly Instructions
Electrical
Mounting
Bracket
Cover (3)
Power Cord (3)