Call Divert; Call Barring - Nokia 002F5S8 User Manual

unsuccessful call attempt. To stop automatic redialling,
press the end key.
Show call duration
●
the length of a call to be displayed during the call.
Speed dial — Select On, and the numbers assigned to
●
the number keys (2 to 9) can be dialled by pressing and
holding the key. See "Speed dial a phone
number", p. 124.
Anykey answer — Select On, and you can answer an
●
incoming call by briefly pressing any keypad key,
except the left and right selection keys, the power key,
and the end key.
Line in use — This setting (network service) is shown
●
only if the SIM card supports two subscriber numbers,
that is, two phone lines. Select which phone line you
want to use for making calls and sending text
messages. Calls on both lines can be answered
irrespective of the selected line. If you select
have not subscribed to this network service, you are
not able to make calls. When line 2 is selected,
shown in the standby mode.
Tip: To switch between the phone lines, press
and hold # in the standby mode.
Line change — To prevent line selection (network
●
service), select Disable
To change this setting, you need the PIN2 code.
© 2008 Nokia. All rights reserved.
— Activate this setting if you want
if supported by your SIM card.

Call divert

Press
divert.
Call divert allows you to divert your incoming calls to your
voice mailbox or another phone number. For details,
contact your service provider.
Select which calls you want to divert and the desired
diverting option. Set the option on (Activate) or off
(Cancel), or check whether the option is activated
status).
Several diverting options can be active at the same time.
When all calls are diverted,
mode.
Call barring and call diverting cannot be active at the same
time.
Line 2 and

Call barring

is
Press
barring.
Call barring (network service) allows you to restrict the
calls that you make or receive with the device. To change
the settings, you need the barring password from your
service provider.
, and select Tools Settings
>
, and select Tools Settings
>
Settings
Phone Call
> >
(Check
is shown in the standby
Phone Call
> >
155