Den-Mat Clinician's Choice Bluewave Manual

Soft tissue diode laser

Advertisement

Distributed by Clinician's Choice,
a division of Den-Mat Holdings, LLC
1017 W. Central Avenue, Lompoc, CA 93436 USA
800.433.6628
clinicianschoice.com
INSTRUCTIONS
FOR USE
from

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Clinician's Choice Bluewave and is the answer not in the manual?

Questions and answers

Summary of Contents for Den-Mat Clinician's Choice Bluewave

  • Page 1 INSTRUCTIONS FOR USE Distributed by Clinician’s Choice, from a division of Den-Mat Holdings, LLC 1017 W. Central Avenue, Lompoc, CA 93436 USA 800.433.6628 clinicianschoice.com...
  • Page 2: Regulatory Compliance

    STOP Important Notes About Your Bluewave Soft Tissue Diode Laser REGULATORY COMPLIANCE IEC 60601-1-9, IEC 60601-2-22; IEC 60825-1:2007; IEC 60601-1-2, Class A Per EN 60601-1-2 as well as to US Federal Regulations for laser WARNING: Do not modify this equipment without authorization of the manufacturer. performance standards set out in 21CFR 1040.10 and 1040.11 except for deviations pursuant to laser notice 50 dated July 26, 2001.
  • Page 3: Repairs And Returns

    REPLACING THE FIBER OPTIC HANDPIECE REPAIRS AND RETURNS INTRODUCTION WARNINGS & CAUTIONS DEVICE WARNINGS AND CAUTIONS In the event that the Bluewave fails to operate correctly, and a The Bluewave laser unit is a dental soft tissue laser surgical/ Clinician’s Choice representative is unable to assist, the unit will debridement device.
  • Page 4: Maintenance Information

    MANUFACTURER’S IDENTIFICATION LABEL: COMBUSTIBLE CHEMICALS AND GASES When using the Bluewave Soft Tissue Diode Laser in contact with MAINTENANCE INFORMATION tissue, make short quick brush strokes in light contact at the lowest All gases that are combustible or support combustion and are used CLEANING INSTRUCTIONS power setting that will remove the target tissue.
  • Page 5: Safety Features

    BATTERY POWER INSTALLING AND REPLACING SINGLE USE CLASS A EMERGENCY SHUTDOWN OPTIONS (FIG. 1, ITEM 6) FIBER OPTIC TIPS The Battery Charge Indicator changes color to represent the Perform any of these actions to terminate laser emissions in the battery capacity. event of a real or perceived emergency: Electromagnetic Environment Guidance (Class A (CISPR 11:2009), Group 1 per...
  • Page 6 PANEL BUTTONS FIBER WRAP POWER ON/OFF SWITCH The laser power and output modes, CW and Pulse, for four (FIG. 4, ITEM 3) typical diode laser procedures are loaded into four button The power switch is located on the rear of the system and must selections labeled Cut, Debride, Perio and Custom.

Table of Contents