Page 3
Illegal operation is punishable by fine or imprisonment or both. THANK YOU! Founded in 1989, BelFone is a leading technology and solution provider of mission and business-critical communications, dedicated to bringing cut-edge communications technologies and empowering our customers with integrated radio solutions.
Please find a certified technician to repair it. ◆If secondary development is required, please contact BelFone or the local dealer for technical assistance. ◆Please keep the surface of radio clean and dry. To clean the radio, use...
Content Unpacking and Device Inspection ..........01 Accessories ................01 IInstallation of Accessories ............02 Install/ Remove the Antenna ........... 02 Install/ Remove the Belt Clip ........... 02 Install Strap ................02 Install/Remove the Battery ............03 Battery Information ..............04 Charging the Battery ...............
Unpacking and Device Inspection Note: The following instructions regarding unpacking are only for BelFone’s distributors, and service agencies or factories authorized by BelFone. After carefully unpacking the radio, identify the items listed in the table below. If any items are missing or have been damaged during shipment please contact dealer or BelFone immediately.
Installation of Accessories Install/ Remove the Antenna Hold the bottom of the antenna and screw it clockwise into the interface on the top of the radio until it is tightened. Turn the antenna anti-clockwise to remove Install/ Remove the Belt Clip Install along the belt clamp slot and hear a "click"...
Install/Remove the Battery Warning! Do not short-circuit the battery, as this may cause damaged or catch fire; Never attempt to remove battery case, as this may cause battery short circuit; Batteries are flammable, don’t throw it into fire or don’t use it on dangerous area. Align the battery with the corresponding grooves on the back of the radio, and then push the battery in parallel until a "click"...
Applicable battery To reduce the risk of injury, please only use the battery and charger specified by Belfone, other batteries may burst, causing bodily injury and property damage. Battery Tips 1.When charging the battery, keep it at a temperature among 5℃—40℃. Temperature out of the limit may cause battery leakage or damage.
Charging the Battery The charger only specified by BelFone is allowed to use. The charge indicator on the battery indicates the charging progress. Charge Steps: 1.Plug the AC adapter into the AC power output. 2.Insert the Micro USB interface into radio. The indicator light on the back of the radio lights red, indicating that charging is started;...
Getting Acquainted ①Channel knob Rotate to select channels 1-16. ②Power switch/volume adjust keys Rotate clockwise to power on, after the radio is powered on, rotate clockwise to increased volume, anti-clockwise to decrease the volume. Rotate anti-clockwise fully to power off. ③LED Indicator When transmitting the LED will glow red, when receiving the LED will glow green.
Basic Operation Power on /off Rotate the power switch/volume adjusting keys clockwise to power on. Rotate the power switch/volume adjusting keys anti-clockwise to power off. Adjusting Volume In the powered-on state, rotate the power switch/volume adjust keys to adjust the volume level.
Functions and Operations Scan Scan is used to monitor the signals of channels on which the "Add Scan" option is set to "On". To begin scanning:long press the SCAN key, there will be a voice prompt: scanning on, and the indicator light will flash green. Scanning starts from the current channel and increases sequentially cycling through all channels.
Frequency Matching Simultaneously press the MONI and SCAN keys, the LED indicator light will flash red and there will be a voice prompt "RFID", and the radio will enter frequency matching mode. At this point, the other party maintains the transmitting state until the LED indicator light of the radio turns green and there is a voice prompt "success", indicating successful frequency matching.
Battery Saver The radio will automatically enter the power saving mode when it has no any operation for a period of time, which can extend the battery life. Low Battery Warning When the battery gets low, there will be a warning tone: “low battery”,please replace the battery or charge the battery in time, otherwise the radio will turn off automatically while battery is too low.
Statement This manual is compiled to be accurate and complete for operator’s use. For any doubt, please contact Belfone. We will give you professional answers. As radio communication technologies develop rapidly, Belfone reserves the right to change product design and specification without prior notice to consumers.
Need help?
Do you have a question about the BF-AP Series and is the answer not in the manual?
Questions and answers