Download  Print this page

Kenwood Heater 2307K Instructions Manual page 4

Delonghi heater instruction manual
Hide thumbs

Advertisement

1. LOCATION
Place heater on floor beneath coldest window in the room or any desired location. Your hea-
ter will minimize the effect of cold drafts.
The heater must not be located immediately below a socket-outlet.
Do not use this radiator in rooms having a surface area less than 4 m
2. POWER CONNECTION
The radiator must be connected to a properly polarized A/C 110/120 V household outlet in
perfect working conditions.
Keep loose clothing or bedding, furniture and flammable material away from the wall outlet
where the heater plug is fitted in.
Your product is equipped with a polarized alternating current line plug (a plug having one
blade wider than the other). This plug will fit into the power outlet only one way. This is a
safety feature. If you are unable to insert the plug fully into the outlet, try reversing the
plug. If the plug should still fail to fit, contact your electrician to replace your obsolete
outlet. Do not defeat the safety purpose of the polarized plug.
3. SWITCHING ON TWO-SWITCH MODELS
Turn thermostat clockwise to the maximum position. Switch on both switches. The lights on
the switches remain on indipendent of the cycling of the thermostat. When room reaches the
desired temperature, turn the thermostat knob counter clockwise very slowly and carefully
until you hear a "click". This will automatically set your unit to cycle on and off at that desired
heat setting.
Note: It will normally require approx.15 minutes to reach operating temperature.
4. USE OF THERMOSTAT
The thermostat operates on room air temperature and not radiator temperature. Counter
clockwise direction - lower number, lower temperature. Clockwise direction- higher number,
higher temperature.
Antifreeze function
Turn the thermostat dial to the
tain a minimum room temperature of approximately 41°F (5°C) thus preventing conditions.
REMINDER
To completely shut unit off, ON/OFF switches must be placed in OFF position.
5. SAFETY DEVICE
A safety device switches the heater off in the event of overheating. To restart the heater, call
the nearest Service Center.
6. MAINTENANCE AND SERVICE
Always remove the plug from the power outlet and allow the radiator to cool. Wipe radiator
with a soft damp cloth, do not use detergents and abrasives.
Should the radiator not be in use over a certain length of time, wind the cable around the hol-
der and store it in a dry place.
This appliance has been built to give many years of trouble free service.
In case of malfunction or doubt, do not try to repair the heater by yourself: it may results in fire
hazard or electric shock.
Call nearest Service Center (see attached list of Service Centers).
4
position and press the switches. The appliance will main-
2
(43 sq. ft.).

Advertisement

Table of Contents
loading

  Related Manuals for Kenwood Heater 2307K