Hitachi L32A403 - 31.51" LCD TV Operating Manual page 13

TV Setup Wizard
Your Hitachi LCD television has a TV Setup Wizard feature which has the ability to help you easily setup the first time you turn on your TV
and find the channels available in your area. Please follow the instructions below.
The First time you turn on your Hitachi LCD TV the Initial Settings
screen will appear. The first step to set is the language of your TV
On screen Menu. Select the language that you prefer. Use the p
and q CURSOR to select and press the SELECT button on the
remote control.
Setup Wizard (1/7)
Please select language ...
English
Spanish
French
Cancel
Navigate
The second and third steps are to set the date and time. There are
two options ; one for automatic setting in which you will select only
the time zone in your area and the second option is a manual setup
for the date and time. Use the CURSOR pad to select and change
the options with the remote control.
Setup Wizard (2/7)
Please set time mode ...
Auto
Manual
Previous Cancel
Navigate Select
SEL
The fourth step is designed to find broadcasting or cable channels.
There are two options, Air for an external antenna and Cable for a
cable system provider in your home. Use the p and q CURSOR
to select and press the SELECT button on the remote control.
Setup Wizard (4/7)
Please select TV RF tuning band ...
Previous
Navigate
Select
SEL
Setup Wizard (3/7)
Please select Time Zone ...
NST MST
AST PST
EST AKST
CST HST
Previous Cancel
Navigate Select
SEL
Setup Wizard (3/7)
Please enter the date and time ...
Year
2009
Month Jan
Date 1
Time 12:00 AM
OK
Previous Cancel
Navigate Select
SEL
Air
Cable
Cancel
Select
SEL
Step 5 will start the scanning feature to find the channels available
on the antenna or cable system. Press the SELECT button on the
remote control to start the channel scan.
Setup Wizard (5/7)
Please check that the RF cable is
connected properly.
Previous
Navigate
The sixth step is the scanning process of the channels, it shows
first the scan of analog channels and then the digital channels.
The scanning process will show how many channels have been
found. Please be patient while the scanning process searches
for the available channels in your area. If you wish to cancel the
process, press the SELECT button on the remote control to cancel
the process.
Setup Wizard (6/7)
Searching, please wait ...
Searching Analog CH
Analog Channels Found
Digital Channels Found
10%
• Once the user cancels the wizard, the wizard will
NOTES
not be shown again.
• If you see the screen above and if you did not
connect your Antenna cables to your TV, turn off
your TV, unplug the power cord and connect your
cables according to the applicable connections
in the "First Time Use" section of this Operating
Guide.
• After completing the TV Setup Wizard, these
screens will not appear again. For updating
and adding the channels available in your area
refer to the New Channel Scan feature on page
33.
The last step is the completion of process, it shows a brief message
and you are ready to view TV programing. This final message will
be shown for a few seconds and then the first detected channel will
be tuned in. You may also press EXIT on the remote control to tune
to the first detected channel.
Setup Wizard (7/7)
Congratulations. TV setup is done.
Start
Cancel
Select
SEL
Channel 3
10
15
Cancel
Cancel
SEL
Exit
EXIT
13