Non-Skid Pads; Cabinet Maintenance - Pioneer SFCRW2500 - Surround Sound Speaker Operating Manual

Standard surround setup
This is a standard multichannel surround soundspeaker setup
for optimal 5.1 channel home theatre sound.
Center
Front left
Listening position
Surround
left
If you have connected to the SX-315 and the above speaker
placement isn't possible, you can select the FRONT
SURROUND MODE on the receiver with the following speaker
placement: Place the surround speakers to the side of the front
speakers and turn them towards the closest wall (right or left).

NON-SKID PADS

If the front, center and surround speakers are placed on a hard
surface, such as wood or tile place four non-skid pads (small)
on the bottom flat surface of the speakers.
Front right
Subwoofer
Surround
right
If the subwoofer is placed on a hard floor, such as wood or tile,
place four non-skid pads (large) on the bottom surface of the
subwoofer.

CABINET MAINTENANCE

Use a polishing cloth or dry cloth to wipe off dust and dirt.
When the cabinet is very dirty, clean with a soft cloth dipped in
some neutral cleanser diluted five or six times with water, and
then wipe again with a dry cloth. Do not use furniture wax or
cleaners.
Never use thinners, benzine, insecticide sprays and other
chemicals on or near the cabinets, since these will corrode
the surfaces.
CAUTION:
The front speakers are equipped with a protection device to
protect the transducers from extreme conditions. Under
these conditions the protection device will activate and stop
the speaker from producing sound. If this happens turn the
volume down to resume normal speaker output.
www.pioneerelectronics.com
3