Table of Contents
Related Manuals for Kohler K-1114-GLA-0
Summary of Contents for Kohler K-1114-GLA-0
- Page 1 Installation and Care Guide Air Bath Retain serial number for reference. Numéro de série du produit: Número de serie del producto:__________________________ Français, page “Français-1” Español, página “Español-1” 1198326-2-E...
-
Page 2: Installation Instructions
Factory-installed components include a blower motor with power supply cord, air piping, and user keypad. -G2M models also include transducers, an amplifier, and a power supply cord. Other than electrical wiring and plumbing, no assembly is needed. 1198326-2-E Kohler Co. -
Page 3: Tools And Materials
• Conventional Woodworking Tools and Materials • Drop Cloth • Construction Adhesive (Optional) • Cement* or Mortar (Optional) • 2x4s • Plastic Film (Optional) • 1/8" (3 mm) Spacers * Do not use gypsum cement. 100% Silicone Sealant Kohler Co. 1198326-2-E... - Page 4 1. Prepare the Site NOTICE: Measure your actual product for site preparation. Note the model number located on the bath blower, then visit the product page at www.kohler.com for additional information. NOTICE: Remote blower installation kit K-1446 is available for relocating the blower.
- Page 5 Secure the Nailing-in Flanges (Alcove Units) Drill a small pilot hole through the nailing-in flange at each stud. Add shims as needed. Use large-head galvanized nails to secure the nailing-in flange to the studs. Nail furring strips to the studs. Kohler Co. 1198326-2-E...
- Page 6 Install the Bath (cont.) Install the Plumbing Insert the drain tailpiece into the trap. Secure the drain tailpiece to the trap. Install the faucet valve. Check the drain connections for leakage. 1198326-2-E Kohler Co.
-
Page 7: Make The Electrical Connections
For additional information on bath operation, see the ″Operating Instructions″ section. Finish the Installation IMPORTANT! Kohler Co. strongly recommends the use of 100% silicone sealant as instructed. Other sealants with high filler contents should be avoided, as they may shrink, separate, and peel over time Install water-resistant wallboard and all finished wall, deck, and floor materials. -
Page 8: Important Safety Instructions
WARNING: Risk of personal injury. Never drop or insert any object into any opening. Use this bath only for its intended purpose as described in this guide. Do not use attachments not recommended by Kohler Co. The bath must be connected only to a supply circuit that is protected by a Ground-Fault Circuit-Interrupter (GFCI)*. - Page 9 Whirlpool hydro-massage action can cause even a small amount of bubble bath, bath soap, shampoo, or bath oil to foam excessively. For this reason, please do not use these products during whirlpool operation. *Outside North America, this device may be known as a Residual Current Device (RCD). Kohler Co. 1198326-2-E...
-
Page 10: Care And Cleaning
NOTE: To restore dull or scratched units: Apply white automotive polishing compound with a clean rag. Rub scratches and dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste wax. Do not wax areas where you walk or stand. 1198326-2-E Kohler Co. -
Page 11: Troubleshooting
Cleaning information, call 1-800-456-4537. Troubleshooting NOTICE: This section is for general aid only. A Kohler Co. Authorized Service Representative or qualified electrician should correct any electrical problems. For warranty service, call 1-800-4KOHLER from within the USA and Canada, or 001-800-456-4537 from within Mexico. -
Page 12: Warranty
Kohler Co. will, at its election, repair, replace or make appropriate adjustment where Kohler Co. inspection discloses any such defects occurring in normal usage within one (1) year after installation. Kohler Co. is not responsible for removal or installation costs. Use of in-tank toilet cleaners will void the warranty.
Need help?
Do you have a question about the K-1114-GLA-0 and is the answer not in the manual?
Questions and answers