Programming Start Up; Programming Shutdown; Self-Diagnosis; Programming The Timer - Delonghi Pac W130E Instructions For Use Manual

P
ROGRAMMING THE TIMER
The appliance can be programmed to start up and shut down
when required.

Programming start up

• Press the button.
The start-up time and message
trol display (fig. 27).
• Press the or
ce to start up.
• When that time is reached, press the OK button to confirm
(fig. 28). The message
display and the
indicate that the timer is active.

Programming shutdown

• Press the OFF button. The shutdown time and message
flash on the remote control display (fig. 29).
• Press the or
ce to shut down.
• When that time is reached, press the OK button to confirm
(fig. 30). The message
display and the
indicate that the timer is active.

SELF-DIAGNOSIS

The appliance has a self diagnosis system to identify a number of malfunctions.
Error messages are indicated on the control panel display screen.
I ... ,
F IS DISPLAYED
L T
OW EMPERATURE
(frost prevention)
P F
ROBE AILURE
(sensor damaged)
buttons to set the time you want the applian-
appears on the remote control
symbol is displayed on the appliance to
buttons to set the time you want the applian-
appears on the remote control
symbol is displayed on the appliance to
WHAT SHOULD I DO
The appliance is fitted with
a frost protection device to
avoid excessive formation
of ice. The appliance starts
up again automatically
when the defrosting pro-
cess is completed.
If this is displayed, contact
your local authorized servi-
ce center.
flash on the remote con-
30
? I ...
F IS DISPLAYED
H
IGH
(safety tank full)
C
LEAN
After descaling or if the alarm reappears too soon after
the last descaling (carried out before the message is dis-
played), reset the alarm by holding the
for 10 seconds.
14
27
28
29
,
WHAT SHOULD I DO
Empty the internal safety
tank, following the instruc-
tions in the "End of season
operations" section (pg.
17). If this reoccurs, contact
your local authorized servi-
L
EVEL
ce center.
This message appears after
about 500 hours of opera-
tion in water mode and indi-
cates that the appliance
requires descaling as descri-
bed in the "descaling" sec-
tion (pg. 17).
?
button down