CONTENTS Safety instructions Care and cleaning Operation What to do if… First use Technical data Daily use Installation Helpful hints and tips Environmental concerns Subject to change without notice. SAFETY INSTRUCTIONS In the interest of your safety and to ensure usable before you discard the old appli- the correct use, before installing and first ance.
Page 3
– avoid open flames and sources of igni- • Frozen food must not be re-frozen once tion it has been thawed out. – thoroughly ventilate the room in which • Store pre-packed frozen food in accord- the appliance is situated ance with the frozen food manufacturer's •...
• The appliance must not be located close in either its refrigerant circuit or insula- to radiators or cookers. tion materials. The appliance shall not • Make sure that the mains plug is accessi- be discarded together with the urban ble after the installation of the appliance.
DAILY USE Freezing fresh food Important! Do not move the glass shelf above the vegetable drawer and the bottle The freezer compartment is suitable for shelf to ensure correct air circulation. freezing fresh food and storing frozen and deep-frozen food for a long time. To freeze fresh foods it is not necessary to change the medium setting.
hear a whirring sound and a pulsating Bottles: these should have a cap and noise from the compressor. This is cor- should be stored in the bottle rack on the rect. door. • The thermic dilatation might cause a sud- Bananas, potatoes, onions and garlic, if not den cracking noise.
• do not exceed the storage period indica- ted by the food manufacturer. CARE AND CLEANING Caution! Unplug the appliance before out through a trough into a special contain- carrying out any maintenance er at the back of the appliance, over the operation.
pliance for two or three hours using this • disconnect the appliance from elec- setting. tricity supply 7. Reload the previously removed food in- • remove all food to the compartment. • defrost (if foreseen) and clean the appli- ance and all accessories Important! Never use sharp metal tools to •...
Problem Possible cause Solution Water flows into the re- The water outlet is clogged. Clean the water outlet. frigerator. Products prevent that water Make sure that products do not flows into the water collector. touch the rear plate. Water flows on the The melting water outlet does Attach the melting water outlet to ground.
The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. INSTALLATION Read the "Safety Information" carefully can only be guaranteed within the specified for your safety and correct operation of temperature range.
Need help?
Do you have a question about the IKE1560-2 and is the answer not in the manual?
Questions and answers