Powercom SNT-1000 User Manual page 37

C old Start function
W hen the main power is not connected to UPS, it is capable of starting with
b attery power for users' needs. Simply start the UPS as the instruction below.
N ote: To avoid accidental battery discharge, cold start function is not available
u ntil the initial connection to the main power.
1 . "ON/OFF" button
Press and hold the "
( a)
Press and hold the "
( b)
w orking.
2. "Status/Enter" button
Use this button to check the content and confirm the selection of UPS.
Press and hold " " button for 1 second to check UPS contents.
(a)
Press once to display status. There are 10 statuses available for users.
(b)
Enter function only uses during settings. Check the" " button for more detail.
(c)
If UPS idles for 20 seconds, the display will return to the main status.
(d)
3. "Settings or Selection" button
Use this button and "ENTER" button to execute the setting.
Press and hold the " " button for 1 second to enter the configurations of UPS.
(a)
Press the " " once to display setting. There are 7 settings available for users.
(b)
Press the " " button to enter the function.
(c)
Press the " " button to select your option.
(d)
Press the " " button to confirmation (YES/NO) of your selected option.
(e)
Press the " " button again to confirm and enable your function.
(f)
If UPS is idle over 10 seconds, the display will return to the main status.
(g)
Turn on the UPS

Ensure installation is correct and successful, and connect the input power cable to
a well-grounded outlet.

Push the "on/off" bottom on the front panel for 3 seconds.
© All rights reserved. All trademarks are property of their respective owners.
https://tm.by
Интернет-магазин
" b utton for 3 seconds to turn on the UPS.
" b utton for 3 seconds to turn off the UPS while UPS is
12