Dell M5200 Owner's Manual page 38

Using Windows 2000
When you attached the cable and turned on the printer and computer, the Found New
Hardware Wizard screen appeared on your computer screen.
Insert the Drivers and Utilities CD, and then click Next.
1
Select Search for a suitable driver, and then click Next.
2
Select Specify a location only, and then click Next.
3
Browse to the location of the printer driver on the Drivers and Utilities CD.
4
D:\Drivers\Win_2000\
Replace D:\ with the letter of your CD-ROM drive (for example, type D:\ where D is
the drive letter of your CD).
Click Open, and then click OK.
5
Click Next to install the driver that is displayed.
6
D:\Drivers\Win_2000\dkaag1da.inf
Click Finish when the software is installed.
7
When the Dell Drivers and Utilities screen appears, choose Install the printer for Use
8
on this Computer only (Personal Installation) to install the additional software for
your printer.
If the Drivers and Utilities CD does not automatically launch, click Start
9
browse your CD drive (for example, type D:\ where D is the drive letter of your CD).
Select SETUP .EXE, and then click OK.
When all the files are installed on your computer, the Congratulations screen appears.
Click Print a Test Page to verify printer setup.
10
Click Finish when the test page prints successfully.
11
Click Exit on the Drivers and Utilities CD screen.
12
3 8 Se t up fo r lo c a l print ing
Run and