Overheating Protection; Mode Selection; Maintenance And Care - Bosch C10 Operating Instructions Manual

Bosch C10 charger I Operating instructions
4.4

Overheating protection

If the device becomes too hot during the charging process, the output power and out-
put current are automatically reduced to prevent damage to the device.

5 Mode selection

1. Press the mode button. The charger will enter the charging mode from the standby
state and the charging LED will light up.
2. Suitable for batteries with capacity of more than 5
WET, EFB, and the majority of GEL batteries, or for AGM batteries in normal state.
Note: Do not connect 6
3. If there is no other operation, it will automatically enter the charging mode in 5
seconds.
Mode
7 Standby
11 Charging mode
(14.7 V / 3.5 A)
10 Fully charged
(≥ 14.7 V)
9 Very low battery
(2 V - 4.5 V)
5.1 Pulse charging
This is an automatic charging function that cannot be selected manually.
If the battery voltage in 12
start of the charging process, the charger will automatically switch to pulse charging.
5.2 Trickle charging phase
The charger has an automatic trickle charging phase with max. 200
5.3 Maintenance phase
When the battery is fully charged, the charger will start the maintenance phase to
keep the battery capacity in full condition.

6 Maintenance and care

Always remove the mains plug from the socket before cleaning the charger. The
charger is maintenance-free.
1. Switch off the device.
2. Use a dry cloth to clean the plastic surfaces of the device.
3. Never use solvents or other aggressive cleaning agents.
4. To maintain operational safety, the devices must only be repaired by the
manufacturer or its service representative using original spare parts.
5. For Li-Ion (LiFePO₄) batteries, please use Bosch C40-Li or C80-Li.
6. For 6 V batteries, please use Bosch C30, C40-Li or C80-Li.
7. For 24 V batteries, please use Bosch C70.
10
V battery.
Indicator Function
◾ Switched on, not charging
◾ Press the mode button once, LED 2 will light up, then
the charger will switch to charging mode.
◾ LED 2 OFF, LED 3 ON means fully charged.
◾ LED 4 ON
V mode is between 4.5
Ah in cold state (0-4
V (± 0.5 V) and 10.5
°C) of 12 V
V (± 0.5 V) at the
mA at full charge.
EN