Table of Contents
Advertisement
44061 Rev 1
23/12/04
Using the sandwich holder
Place your sandwich in the sandwich
holder.
Place the loaded sandwich holder into
one of the bread slots. Set the browning
control to the required setting. Depress the
relevant bread lever.
WARNING: Do not overfill the
sandwich as the heated contents may
leak into the toaster.
After the set time has been reached the
toasting cycle will finish. Remove the
sandwich and holder.
11:39 AM
Page 5
5
Additional points
• In order to achieve uniform browning, we
recommend you wait a minimum of 30
seconds between each toasting, so that
the control can be automatically reset.
• If toasting one slice only, you may need
to adjust the browning control to a
slightly lower setting.
• Note: you will also notice a slight
variation in toast colour on one side of a
single slice.
• Stale bread toasts more rapidly than
fresh bread. Therefore, the browning
control should be set at a lower setting
than usual.
• All sorts of bread can be used as well as
teacakes, small rolls etc. Slices should
not however be so thick as to cause
burning or jamming within the bread
slots.
• When toasting 2 or more slices it is
recommended they are of equal size and
freshness.
• Allow the toaster to cool fully before
putting away.
Advertisement
Table of Contents
