Indoor Unit; Remote Controller; Outdoor Unit - Mitsubishi Electric Ecocore Ap 42 Series Operating Instructions Manual

N
ame of Each Part

Indoor unit

Front panel
Air filter
Air cleaning filter
(Anti-Allergy
Enzyme filter)
(Electrostatic
Horizontal vane
anti-allergy
enzyme filter,
Air outlet
option)
Fan guard
Heat exchanger
Operation indicator lamp
Remote control receiving
section

Outdoor unit

Outdoor units may be different in appearance.
Wi-Fi interface
(VGK type only)
Air inlet
Page 13
Emergency
operation
switch
Page 11
Air inlet (back and side)
Refrigerant piping
Drainage hose
Air outlet
Drain outlet

Remote controller

Battery replacement indicator
Page 5
Operation dis-
play section
Temperature
buttons
Page 6
Operation
select button
Page 6
ECONO COOL
button
Page 8
I-SAVE button
Page 8
NIGHT MODE
button
Page 9
Clock button
Page 5
Remote controller holder
• Install the remote
controller holder in a
place where the signal
can be received by the
indoor unit.
• When the remote
controller is not used,
place it in this holder.
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard from
the indoor unit when the
signal is received.
Off/on (stop/operate)
button
Fan speed control
button
Page 7
Wide vane button
Page 7
Vane control button
Page 7
Time, Timer set buttons
Page 7, 9
Increase time
Decrease time
Weekly timer set but-
Page 5, 10
tons
Reset button
Page 5
Lid
Slide the lid down
to open the remote
controller. Slide it down
further to get to the
weekly timer buttons.
Only use the remote controller provided
with the unit.
Do not use other remote controllers.
If 2 or more indoor units are installed in
proximity to one another, an indoor unit
that is not intended to be operated may
respond to the remote controller.
En-4