T Imer Operation (On/Off Timer) - Mitsubishi Electric Ecocore Ap 42 Series Operating Instructions Manual

● OPERATING INSTRUCTIONS ●
N
IGHT MODE Operation
NIGHT MODE changes the brightness of the operation indicator,
disables the beep sound and limits the noise level of the outdoor unit.
1
Press during operation to activate NIGHT MODE.
• The operation indicator lamp dims.
• The beep sound will be disabled except that emitted when the opera-
tion is started or stopped.
• Noise level of the outdoor unit will be lower than that mentioned in
SPECIFICATIONS.
Press again to cancel NIGHT MODE.
Note:
• The cooling/heating capacity may drop.
• Noise level of the outdoor unit may not change after start-up of the unit, dur-
ing the protection operation, or depending on other operating conditions.
• The fan speed of the indoor unit will not change.
• The operation indicator lamp will be hard to be seen in a bright room.
• Noise level of the outdoor unit will not decrease during Multi system operation.
En-9
T
imer Operation (On/Off Timer)
1
Press or during operation to set the timer.
(on timer) : The unit turns on at the set time.
(off timer) : The unit turns off at the set time.
* or blinks.
* Make sure that the current time and day are set correctly.
2
(Increase) and
Press
time of timer.
Each press increases or decreases the set time by 10 minutes.
• Set the timer while or
Press or again to cancel timer.
Note:
• On and off timers can be set together. mark indicates the order of timer
operations.
• If power failure occurs while on/off timer is set, see
function".
Page 5
(Decrease) to set the
is blinking.
page 11 "Auto restart