Frost Precautions; Cleaning The Inlet Hose And The Valve Filter - Electrolux Ewt 1262Isw User Manual

16 www.electrolux.com
3.

12.6 Frost precautions

If the appliance is installed in an area
where the temperature can be less than
0°C, remove the remaining water from
the inlet hose and the drain pump.
Do this procedure also when
you want to do the
emergency drain.
1. Close the water tap.
2. Remove the water inlet hose.
3. Remove the drain hose from the rear
support and unhook it from sink or
spigot.
4. Put the ends of each drain and inlet
hose in a container. Let the water
flow out of the hoses.

12.7 Cleaning the inlet hose and the valve filter

1.
1
2
3
5. Set the Drain programme and let it
operate until the end of the cycle.
6. Turn the programme knob to position
to deactivate the appliance.
7. Disconnect the appliance from the
mains socket.
WARNING!
Make sure that the
temperature is more than
0°C before you use the
appliance again. The
manufacturer is not
responsible for damages
caused by low temperatures.
2.