Dell POWEREDGE EMU01 Hardware Owner's Manual page 65

Dell personal computer user manual
Hide thumbs Also See for POWEREDGE EMU01:
Table of Contents

Advertisement

3 If you are adding a processor to an empty socket, perform the following steps:
Remove the protective cover from the processor socket. See Figure 3-12.
a
Pull the socket-release lever 90 degrees upward. See Figure 3-12.
b
Lift the processor shield. See Figure 3-12.
c
4 Install the processor in the socket.
NOTICE:
Positioning the processor incorrectly can permanently damage the system board or the processor when
you turn the system on.
If the release lever on the processor socket is not fully open, move it to that position.
a
With the processor and the socket keys aligned, set the processor lightly in the socket.
b
NOTICE:
Do not use force to seat the processor. When the processor is positioned correctly, it fits easily into the
socket.
Close the processor shield. See Figure 3-12.
c
Rotate the socket release lever back down until it snaps into place, securing the processor. See
d
Figure 3-12.
5 Install the heat sink.
NOTE:
If you did not receive a replacement heat sink, use the heat sink that you removed in step 9.
If you receive a heat sink and pre-applied thermal grease with your processor kit, remove the
a
protective sheet from the thermal grease layer on top of the heat sink. See Figure 3-11.
If you did not receive a replacement heat sink with your processor kit, apply new thermal grease:
Using a clean lint-free cloth, remove the existing thermal grease from the heat sink.
Open the grease packet included with your processor kit and apply thermal grease evenly to
the top of the processor.
Place the heat sink onto the processor. See Figure 3-11.
b
Close one of the two heat sink retention levers until it locks. See Figure 3-11.
c
Close the remaining heat sink retention lever.
d
NOTICE:
If you are adding a third and fourth processor, you must also install a voltage regulator module (VRM) for
each processor. See "Installing a VRM" on page 66.
6 Replace the cooling shrouds. See "Replacing the Cooling Shrouds" on page 50.
7 Close the system. See "Closing the System" on page 47.
8 Restart the system.
As the system boots, it detects the presence of the new processor(s) and automatically changes the
system configuration information in the System Setup program.
Installing System Components
65

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Poweredge 6950

Table of Contents