iNSTRUCTiONS
When the Self-Clean
cycle is done:
t.
The time of day,"DOOR LOCKED" and "CLEAN" icon wiii remain
in the display.
2.
Once the oven has cooled down for approximately
1 HOUR, and
the "DOOR LOCKED"
icon is no longer displayed, the oven
door can then be opened.
Stopping
or Interrupting
a Self-Cleaning
cycle:
if it becomes necessary to stop or interrupt a Self-Cleaning cycle
due to excessive smoke or fire in the oven:
PRESS
DISPLAY
1.
Press@.
2.
Once the oven has cooled down for approximately
1 HOU R and
the "DOOR LOCKED" icon is no longer displayed,the oven door
can then be opened (Fig. 7).
Fig.7
Adjusting Your Oven Temperature
The temperature in the oven has been pre-set at the factory. When first using the oven, be
sure to follow recipe times and temperatures.
If you think the oven is too hot or too cool, the
temperature in the oven can be adjusted. Before adjusting, test a recipe by using a
temperature setting that is higher or lower than the recommended temperature. The baking
results should help you to decide how much of an adjustment is needed.
INSTRUCTIONS
To adjust
the oven temperature
higher:
PRESS
1.
2.
Press
for 6 seconds (Fig. 1).
To increase the temperature use the number pads to enter the
change. (Example30°F)
3___
(Fig. 2).
desired
The
temperature may be increased as much as 35°F (19°C).
3.
Press_
to accept the temperature change and the display
return to the time of day (Fig. 3). Press _
to reject
will
the
change if necessary.
To adjust
the oven temperature
lower:
©
1.
2.
Press,
for 6 seconds (Fig. 4).
To decrease the temperature use the number pads to enter the
change /Example-30°F/
@ and t hen p ress
desired
_
(Fig. 5).
temperature may
as
as
The
be decreased
much
35°F (19°0).
3.
Press _
to accept the temperature change and the display
return to the time of day (Fig. 6). Press @
to reject
will
the
change if necessary.
©
Note: The oven temperature adjustments made with this feature will
not change the Self-Clean cycle temperature.
29
DISPLAY
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Need help?
Do you have a question about the PLGFMZ96ECD and is the answer not in the manual?
Questions and answers