Dell MTC2 User Manual page 95

CAUTION: A new battery can explode if it is incorrectly installed. Replace the
3-V CR2032 battery only with the same or equivalent type recommended by the
manufacturer. Discard used batteries according to the manufacturer's
instructions.
Record all the screens in the system setup program (see page 103) so that you can
1
restore the correct settings when your perform step 7.
Remove the computer cover (see page 76).
2
Locate the battery socket (see page 79).
3
Remove the battery by carefully prying it out of its socket with your fingers or with a
4
blunt, nonconducting object such as a plastic screwdriver.
NOTICE: To avoid damage to the system board while you pry the battery loose, be sure to insert
the plastic screwdriver between the battery and the socket (not the system board).
battery socket
Insert the new battery into the socket with the side labeled "+" facing up and snap the
5
battery into place.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then
plug it into the computer.
Connect your computer and devices to electrical outlets, and turn them on.
6
Access the system setup program (see page 103) and restore the settings you recorded
7
in step 1.
Properly dispose of the old battery (see page 12).
8
battery
Rem ov i ng a n d I n s t a l l i n g Par t s
95