Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Osmofilter Horizon ECO
Summary of Contents for Osmofilter Horizon ECO
- Page 1 Manual de usuario User’s manual Manuel d’utilisation...
-
Page 3: Table Of Contents
INDEX USER’S MANUAL PRESENTATION AND INTRODUCTION | WHAT IS THE INVERSE OSMOSIS? WATER QUALITY WATER POLLUTION | PREVIOUS WARNINGS | TECHNICAL DATA SYSTEM INSTALLATION PROCEDURE | START UP OPERATION OF THE SYSTEM WITHOUT PUMP OPERATION OF THE SYSTEM WITH PUMP SYSTEM SANITATION PREFILTER TREATMENT | DEPOSIT TREATMENT, POST-FILTER AND FAUCET... -
Page 4: User's Manual
USER’S MANUAL Reverse osmosis membrane pore: 0,0001 microns Virus: 0,2 to 0,4 microns Bacteria: 0,4 to 1 microns Figure 1 Reverse osmosis is the reversal of the natural flow of osmosis. In the water purification system, the goal is to dilute the salt solution but separate the pure water from the salt and other contaminants. -
Page 5: Water Pollution | Previous Warnings | Technical Data System
USER’S MANUAL 4. WATER POLLUTION void. Please check that the product is in good Environmental water is increasingly contaminated by condition after removing the packaging, and waste from domestic, agricultural and industrial origin. check whether the accessories are complete. Those of domestic origin (human waste, washing or 5. -
Page 6: Installation Procedure | Start Up
USER’S MANUAL 6. INSTALLATION PROCEDURE B. Make sure the membrane is not installed when cleaning filters. It is recommended that the installation of the equipment 10. Check that all joints are correctly connected, tight be carried out by an authorized technical service. and that there are no water leaks. - Page 7 USER’S MANUAL losses on any connection. If so, it will be sealed with Teflon by manual tightening (never with metal keys). At this time, the pump system can be modified to stop by filling the tank on the maximum pressure switch (factory regulator).
-
Page 8: Operation Of The System Without Pump
USER’S MANUAL 8. OPERATION OF THE SYSTEM WITHOUT PUMP outlet of the membrane holder (6) is connected to the drain connection clamp (12), which is located on the Explanation of the water process when installing your water discharge pipe to the sewer. equipment. -
Page 9: Operation Of The System With Pump
USER’S MANUAL 9. OPERATION OF THE SYSTEM WITH PUMP discharge pipe to the sewer. Explanation of the water process when installing your PARTS OF THE SCHEME equipment. We must open the water flow by turning the connection Connection valve valve knob (1) until it is parallel with the tubing. Sediment filter GAC carbon filter The water will begin its journey through the previous... -
Page 10: System Sanitation
USER’S MANUAL Treatment of pre-filters, accumulator tank, post-filter and tap. 10. SYSTEM SANITATION Required material: • Manual valve • Measuring cup and connectors • Hydrogen peroxide (0.5 L) • Brush • Single-use vinyl gloves • Easy-rinse soap or detergent • Food lubricant •... - Page 11 USER’S MANUAL 11. PREFILTER TREATMENT To empty the measuring cup, before opening it, have a container within reach where you can empty it, as it will You must install the dosing cup in the inlet pipe to the be full of water. equipment.
-
Page 12: Rinse
USER’S MANUAL OPEN 13. RINSE To rinse the tank with tap water, proceed as follows: To start, open the tap and empty the tank. Close the dispensing tap and open the inlet stopcock for 1 minute to refill the tank with tap water. Close the stopcock, open the dispensing tap and empty the tank. -
Page 13: System Maintenance
SYSTEM MAINTENANCE It is important that the maintenance of your equipment is carried out by an official equipment service, who will use original spare parts and offer you a maintenance contract and a service guarantee. Any manipulation of the equipment or use of a non-original spare part by a company or person other than our distributors will invalidate the warranty of your equipment, as well as that of its official distribution. -
Page 14: Troubleshooting
TROUBLESHOOTING PROBLEM RESOLUTION The following situations can be handled by ourselves. If it cannot be solved, please ask professional mainte- nance personnel for help to carry out thorough inspec- tion and maintenance. It is normal for the machines to make a slight noise during operation. PROBLEM POSSIBLE CAUSE SOLUTION... -
Page 15: Customer Information
WARRANTY CUSTOMER INFORMATION: THE GUARANTEE DOES NOT EXTEND TO: Mr. / Mrs: Replacement, repair of parts caused by wear, due to normal equipment use, such resins, Address: polyphosphates, sediment cartridges, etc..as ZIP Code and location: indicated in the instruction manual of the Phone number: equipment. -
Page 16: System Installation Log
EQUIPMENT INSTALLATION LOG NOTICE: Read this manual carefully. If you have any Clearly inform about the use, handling and questions, please contact the technical support maintenance required by the equipment to ensure service (T.S.S.) of your distributor. The data marked proper operation of water. -
Page 17: Technical Data
SYSTEM CONTROL AND MONITORING NOTICE DATE TECHNICAL DATA Name: Installation Signature or stamp: Maintenance Warranty Inspection Repair Name: Installation Signature or stamp: Maintenance Warranty Inspection Repair Name: Installation Signature or stamp: Maintenance Warranty Inspection Repair Name: Installation Signature or stamp: Maintenance Warranty Inspection... - Page 18 SYSTEM CONTROL AND MONITORING NOTICE DATE TECHNICAL DATA Name: Installation Signature or stamp: Maintenance Warranty Inspection Repair Name: Installation Signature or stamp: Maintenance Warranty Inspection Repair Name: Installation Signature or stamp: Maintenance Warranty Inspection Repair Name: Installation Signature or stamp: Maintenance Warranty Inspection...
- Page 20 REVERSE OSMOSIS...
Need help?
Do you have a question about the Horizon ECO and is the answer not in the manual?
Questions and answers