Norman Fauxwood Hardware Installation Instructions

N300738-10
65101-21755-J
Fauxwood & Normandy Blind
Optional Hardware Installation
Instructions
Valance Connector Valance Connector
(For FW Blind) (For Wood Blind)
2 " Screw
Shim
(For OB only) (For Shim)
Getting Started
Prior to installation, please make sure your
NOTE:
hands are clean and free from any dirt or oil that
could cause damage to the blind.
Recommended Tools
●
Measuring Tape
●
Pencil
●
Level
●
Screwdriver
●
Power drill
(1/4" hex driver and drill bit)
You will need to use the following fasteners for
your particular mounting surface.
Surface Fastener
#8x2" Screws
Wood
(Provide)
Wall Anchors,
Drywall/Plaster
Expansion Bolts
(Not Provide
Sheet Metal Screws
Metal
(Not Provide)
Hardware Standard Quantity
X≤ 37"
Blind 37"＜ 47"＜
X≤47" X≤75"
Width(X)
1pcs for extend distance 3/8"
Shim
2pcs for extend distance 11/16"
2" Screw
(For Bracket with
4 6 8
Shim)
How to install Valance Connector
Valance Connector is only supplied for connecting
spliced valances.
For Fauxwood Blind: Put the valance connector
into the slot on the back of the valance as below
drawing:
For 3.25" Designer Crown Valance:
The valance is connected as below drawing:
For 2.5" Modern Curved Valance:
75"＜
X≤96"
The valance is connected as below drawing:
10
For Wood Blind: I nsert the valance connector into
the slot on the back of the valance as below
drawing:
! Make sure the wider side is facing downwards.
! Do not remove the fiber tape and wood block
For 2.5" Contempo Valance:
Wood block
Fiber tape
The valance is connected as below drawing:
For 3.25" Designer Crown Valance:
Wood block
Fiber tape
The valance is connected as below drawing: