CMi C-HS-30 Translation Of The Original Instructions page 23

– Set the hexagonal nut (17) on both sides
of the unit in such a way that the lower
blade (18) and the spindle blade (19) can
barely be heard touching.
Turn the hexagonal screw clockwise to move
the lower blade towards the spindle blade.
Turn the hexagonal screw anti-clockwise to
move the lower blade away from the spindle
blade.
Cutting test
DANGER! Risk of cuts! When car-
rying out a cutting test always wear
protective gloves.
– Turn the lawn mower upside down.
– Hold a piece of paper between lower
blade (18) and the spindle (19) and turn
the spindle carefully by hand.
All of the blades should cut the paper evenly
along the entire length of the lower blade. The
spindle should turn freely.
Note: Always adjust both hexagonal
nuts evenly. Set the hexagonal nuts
gently and carefully.
Storage, transportation
Storage
DANGER! Risk of injury! Store the
unit in such a way that it cannot be
started by unauthorised persons.
Ensure that no one is able to hurt
themselves on the stored unit.
NOTICE! Machine damage! Do not
stored unprotected in a damp environ-
ment.
– Clean unit before storing.
Error/Fault
Strange noise.
Cut result is not sufficient.
If you can't fix the fault yourself, contact your
nearest vendor. Please be aware that any
improper repairs will also invalidate the war-
ranty and additional costs may be incurred.
– Grease the blades lightly if you intend to
– Store the unit in a dry place.
Transportation
– When dispatching, try to use the original
Disposal
Disposing of the device
Contact your community authorities for infor-
mation regarding the correct disposal of the
device.
By disposing of the device correctly you are
ensuring that it will be recycled or processed
for reuse. This helps prevent hazardous
material from entering the environment.
Disposing of the packaging
The packaging is made of cardboard and
separately labelled foil which is also recycla-
ble.
– Take these materials to a recycling centre.
Troubleshooting
What to do when something doesn't
work...
Malfunctions are often caused by minor
faults. You can easily remedy most of these
yourself. Please consult the following table
before contacting the vendor. You will save
yourself a lot of trouble and possibly money
too.
Cause
Screws/parts come loose?
Foreign objects in the blades? Remove foreign objects.
Blade damaged?
Blade set incorrectly?
Blade set incorrectly?
Blade is blunt?
store for an extended period of time.
packaging, if possible.
DANGER! Risk of injury! Unprofes-
sional repairs may mean that your unit
will no longer operate safely. This
endangers you and your environ-
ment.
Remedy
Tighten screws.
Get the blades sharpened.
► Setting the cutting mecha-
nism – p. 22.
► Setting the cutting mecha-
nism – p. 22.
Get the blades sharpened.
GB
23