NEC VERSA LX Manual page 151

Message
Address line is short
C: Drive Error
C:Drive Failure
Cache Memory Bad, Do
Not Enable Cache
CH-2 Timer Error
CMOS Battery State
Low
CMOS Checksum
Failure
CMOS System Options
Not Set
CMOS Display Type
Mismatch
CMOS Time and Date
Not Set
Diskette Boot Failure
DMA Error
DMA#1 Error
Post Error Messages
What To Do
Error in the address decoding circuitry on the system
board. Contact your NECC service representative for
service work.
Hard disk drive C: does not respond. Confirm that C:
hard disk type in Setup is correct.
Hard disk drive C: does not respond. You may need to
replace the hard disk drive. Contact your NECC service
representative for service work.
Cache memory is defective. It must be replaced.
Contact your NECC service representative for service
work.
Most ISA computers include two timers. There is an
error in timer 2. Contact your NECC service
representative for service work.
CMOS RAM is powered by a battery. The battery power
is low. Connect the system to AC power to charge the
CMOS battery. If the battery does not charge, contact
your NECC service representative to replace the CMOS
battery.
After CMOS RAM values are saved, a checksum value
is generated for error checking. The previous value is
different from the current value. Run Setup to reset the
value.
The values stored in CMOS RAM are either corrupt or
nonexistent. Run Setup to reset the value.
The amount of memory on the system board is different
than the amount in CMOS RAM. Run Setup to reset the
value.
Run Setup to set the time and date.
The boot diskette is corrupt. It cannot be used to boot
the computer. Use another boot disk and follow the on-
screen instructions.
Error in the DMA controller. Contact your NECC service
representative to replace the CMOS battery.
Error in the first DMA channel. Contact your NECC
service representative for service.
Solving System Problems 7-5