Using The Usb Cd-Rom Or Cd-R/Rw Drive - NEC VERSA LITEPAD TABLET PC Manual

Eject Button — Opens the drive tray. Press this button to open the
tray and load or remove a CD from the drive.
Drive Status LED — Lights during data read, and for the
CD-R/RW drive, write data operations. When the LED is lit, do not
open the drive tray, unplug the USB cable, or turn off the NEC
Versa LitePad tablet PC. Doing so might cause the loss of data
from the CD.
USB Cable Connectors — Connect the USB cable end with the
smaller interface connector to the USB drive; connect the other end
to the USB/power ports on the NEC Versa LitePad tablet PC.
Emergency Eject Hole — Allows you to manually open the drive
tray and remove a disc from the drive if the Eject button function is
disabled by software or a power failure.
To open the tray and remove a disc in an emergency, use the
emergency eject tool at the rear of the drive. Press the tool into the
hole to release the tray.
Ease of use — The USB CD-ROM and CD-R/RW drives can be
disconnected or connected to your tablet PC at any time, with tablet
PC power on or off (see the next section).

Using the USB CD-ROM or CD-R/RW Drive

To use the USB CD-ROM or CD-R/RW drive, follow these steps.
Connect the USB cable.
1.
Power on your tablet PC, if it is not already on.
2.
If this is the first time the USB drive is connected, a New
Hardware Found message displays on your screen and a hardware
driver automatically installs for your drive.
Press the eject button on the drive to open the drive tray. Put your
3.
CD on the tray, print side up.
Plug the USB cable with the smallest USB connector into the
back of the drive.
Plug the other end of the USB cable into the USB and power
ports on your tablet PC.
Adding Expansion Devices 5-7