Replacing The Hard Drive Cage; Memory - Dell XPS PP06XA Owner's Manual

Replacing the Hard Drive Cage

1 Place the hard drive cage upside down on the bottom of the computer with
the SATA connectors and cables aligned, and then firmly press the cables
onto the hard drives' connectors.
2 Flip the hard drive cage over and into the hard drive bay.
3 Tighten the screws on the drive cage.
4 Replace the hard drive cover and tighten the screws.
5 If you have replaced the primary hard drive with a new hard drive that is
not already pre-imaged, install the operating system and drivers for your
computer. See "Restoring Your Operating System" on page 140 and
"Reinstalling Drivers and Utilities" on page 136.

Memory

You can increase your computer memory by installing memory modules on
the system board. See "Specifications" on page 171 for information on the
memory supported by your computer. Install only memory modules that are
intended for your computer.
NOTE:
In order to take advantage of the dual channel bandwidth capability, both
memory slots must be populated and must match in size.
NOTE:
Memory modules purchased from Dell are covered under your computer
warranty.
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions located in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on the back of the computer).
NOTICE:
To avoid damaging the system board, you must remove the battery before
you begin working inside the computer.
1 Follow the procedures in"Before You Begin" on page 149.
2 Ground yourself by touching one of the metal connectors on the back of
the computer.
NOTE:
the computer.
If you leave the area, ground yourself again when you return to
Adding and Replacing Parts
155