Replacing a Hard Drive in the Hard Drive Cage
1 Remove two screws on each side of the hard drive cage to free the hard
drive, then lift the drive out of its tray in the cage.
NOTICE:
packaging. See "Protecting Against Electrostatic Discharge" in the Product
Information Guide.
2 Remove the new hard drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
3 Place the new hard drive into the drive cage tray and secure it with two
screws on each side.
Install the hard drive so that the manufacturer's label faces the
a
bottom of the drive cage and the SATA connectors are at the open end
of the cage.
Install the primary hard drive in the tray labeled 0. You can install a
b
secondary hard drive in the tray labeled 1.
154
Adding and Replacing Parts
When a hard drive is not in the computer, store it in protective antistatic
1
screws
2
hard drive cage
1
2