NEC MOBILEPRO P300 Manual page 17

Charge the battery as follows.
Position the cover so that it does not cover the back and front of the MobilePro.
1.
Plug the MobilePro into the cradle.
2.
Plug the AC adapter into the power port on the back of the cradle.
3.
If you are not using the cradle, plug the AC adapter directly into the power port on the
bottom of the MobilePro.
A – Battery Charging LED
B – MobilePro
C – Cradle
Plug the other end of the AC adapter into a grounded 115-volt AC outlet.
4.
The battery-charging LED lights amber, indicating that the battery is charging.
!
You can also check the power remaining indicator.
!
When the battery is charged, the following occurs.
5.
The battery-charging LED lights green.
!
The power remaining indicator indicates 100%.
!
Now calibrate and activate your MobilePro (see "Calibrate and Activate the MobilePro" in the
following section). Calibration must be done to ensure proper operation of your MobilePro.
You can leave the MobilePro in the cradle and the AC adapter connected to keep your battery
charged.
Note
Whenever possible, keep your MobilePro connected to the AC adapter and a power
source. Doing so keeps the battery charged.
Charging the Battery
D – AC Adapter
E – Power Connector
Get Started 1-11