FIRST TEAM SPORTS Teammate Portable Player Bench General Assembly Instructions

First Team Sports, Inc.
Teammate Portable Player Bench
General Assembly Instructions
PLEASE NOTE: This assembly diagram is for general reference purposes only. Your bench
configuration may differ from the one shown above.
1. Secure 2 rubber foot pads to the bottom of each bench leg using the #10x1" Philips machine screws,
flat washers, lock washers and hex nuts provided.
2. Lay seat plank face down on a working tabletop surface
3. Using the pressure clamps, 3/8"x2" carriage bolts and hardware provided, loosely secure each leg to
the seat plank as shown in diagrams A and B.
4. Space legs appropriately. Legs should be spaced on 72" centers with approx. 18" of seat plank outside
the outermost legs. (The number of legs you receive will be based on the length of your bench)
5. Be sure pressure clamps are positioned properly and tighten. PROPER PRESSURE CLAMP
POSITIONING IS CRUCIAL TO THE OVERALL STRENGTH OF THE ASSEMBLY. MAKE SURE
PRESSURE CLAMPS ARE CENTERED AND SQUARE, AS IN THE ILLUSTRATION IN DIAGRAM B.