Fresh Water Connection - Haier 300 Series User Manual

NZ AU

Fresh Water Connection

>10mm
1. Take note of water connection requirements.
The dishwasher has a single valve water connection.
We recommend a cold water connection for best performance
and energy efficiency.
The incoming water temperature shouldn't exceed 25°C.
2. Take note of the permitted water pressure extremes.
Lowest: 0.3 bar = 3 N/cm = 30kPa
Where pressure is below 1 bar, contact with qualified plumbers.
Highest: 10 bar = 100 N/cm
Where pressure is above 10 bar, a pressure reduction valve
must be installed. Contact with qualified plumbers.
3. Connect the water inlet hose to an accessible water tap with a 3/4"
BSP connector (see fig.A). Ensure that there is no kink in the inlet
hose, because this will restrict the flow of water. A 90° bend requi-
res a minimum height of 200 mm for a kink-free curve.
Ensure incoming water is clear. If the water pipes have not
been used for a long period, let the water run in the pipes, to
make sure it is clear with no impurities. If not, it will result in
the water inlet hose getting blocked and damaging the
appliance.
If required, use a filter insert to filter out deposits from the
piping. The filter insert is available from your authorised
service centre or customer care.
4.
Tighten the hose coupling a further half turn after seal contact.
5.
Confirm that the connections don't leak.
IMPORTANT!
The appliance should be connected to
the water main using the new water
inlet hose supplied. Old hoses shouldn't
be used.
Don't shorten the inlet hose.
fig.A
Installation
2
2
= 1MPa
6