Haier 300 Series User Manual page 30

Troubleshooting
Problem
Acoustic alarm,
display shows
ALARMCODE
Leak: The drain
pump runs
permanently.
Washing Results are not satisfactory
The dishes are not
clean.
Whitish streaks,
stains or bluish layers
on glasses and dishes.
29
Possible cause
Anti-flood device is on:
• There are water leakages
in the appliance.
•
The water inlet valve is
open and blocked.
滚滚长江东
• The drainage is blocked.
Filters are clogged.
Filters are not correctly assem-
bled and installed.
Spray arms are clogged.
Program was not applicable for
the type of load and food
remnants.
Incorrect position of the items
in the baskets. Water could not
wash all items.
Spray arms could not turn freely.
No detergent or insufficient
quantity of detergent in the deter-
gent dispenser.
The wash cycle was interrupted
by a long break.
The released quantity of rinse
aid is too much.
The quantity of detergent was
too much.
Multitab detergent tablets used
with a short program might
not fully dissolve.
Possible Solution
•
Close the water tap.
Disconnect the appliance
•
from the power supply.
逝 水
Contact Service.
•
Clean the filters.
Make sure that the filters are
correctly assembled and installed.
Rem ove remaining food remnants
with a thin pointed object.
Make sure that the program is
applicable for the type of load and
food remnants.
Make sure that the position of the
items in the baskets is correct and
that the water can easily wash all
items.
Make sure that the position of the
items in the baskets is correct and
does not cause the blockage of the
spray arms.
Make sure that you add the correct
quantity detergent in the dispenser
before you start a program.
Do not open the door or cut power
supply during the wash cycle.
Decrease the released quantity of
rinse aid. Refer to section
DIFFERENT SETTINGS FOR RINSE
AID.
Make sure that you add the correct
quantity of detergent in the dispenser
before you start a program.
Select a longer program when
using Multitab detergent tablet . s.
NZ AU