FAAC ADYX TE4433H Programming Manual

Programming of your new remote control
There are several methods for programming your new remote control
From a remote control that has already been programmed:
1. Place yourself next to the receiver.
2. Take an old, fully functional remote control and your new remote control. Place the two
remotes min. 50 cm apart.
3. Press the button P1 and P2 on the already-programmed remote control simultaneously (fig.
1). Hold them pressed. Wait 5 seconds. Release the buttons.
4. Press the button on the old remote you want to copy. Let it go.
5. During the next 10 seconds, press the same button on the new remote control for 1 second.
6. Repeat the process for any additional buttons you want to program.
7. Wait 10 seconds.
8. Your new remote control is programmed.
From the receiver:
1. Open the casing of your receiver. It is located next to your motor.
2. On the receiver circuit board (fig 2), press the programming button SW1. The receiver LED
light illuminates (DL1). Let the button go.
Programming Manual
ADYX TE4433H - FAAC TE4433H
http://www.remotecontrol-express.com