Dell LATITUDE Latitude C600 Service Manual page 42

42 Re m o vi n g a n d Re p l a c i n g Par ts
NOTICE: Read "Preparing to Work Inside the Computer" before performing
the following procedure.
Remove the hard drive.
1
Remove the keyboard.
2
NOTICE: You must remove the display assembly before you remove the
palmrest assembly; the display assembly hinges pass through the back of the
palmrest assembly.
Remove the display hinge cover and display assembly.
3
Turn the computer over and remove the three M2.5 x 12-mm screws
4
that are labeled with a "circle P ."
Remove the two M2 x 3-mm screws that are located in the hard drive
5
bay labeled with a "circle P ."
Turn the computer over, and remove the three M2 x 3-mm screws that
6
secure the palmrest to the bottom case assembly.
• Remove the two M2 x 3-mm screws that are located on the back
edge of the bottom case assembly, underneath the display
assembly.
• Remove the M2 x 3-mm screw located underneath the keyboard,
on the right side of the bottom case assembly, next to the
microprocessor thermal cooling assembly.
Pull up on the pull tab that is attached to the palmrest flex cable
7
connector to remove it from the touch pad connector on the system
board assembly.