18
Re m o vi n g a n d Re p l a c i n g Par ts
Push down on the drive door until it snaps into place.
2
Replace the M3 x 5-mm screw in the hard drive door.
3
Memory Module
M e m o r y M o d u l e C o v e r
Removing the Memory Module Cover
NOTICE: Disconnect the computer and any attached devices from electrical
outlets, and remove any installed batteries.
NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or
by touching an unpainted metal surface on the computer.
NOTICE: Read "Preparing to Work Inside the Computer" before performing
the following procedure.
Remove the memory module cover:
1
Use a coin or flat-blade screwdriver to release the two captive
a
screws that secure the memory module cover.
Place your finger under the cover at the indentation and lift and
b
slide the cover open.