Summary of Contents for Tech West ELITE ROCKY ACOR2D1
Page 1
ELITE SERIES ROCKY OILLESS COMPRESSOR INSTALLATION, USER AND SERVICE MANUAL Manufacturers of Dental Vacuum and Air Systems 2657 N. Argyle Ave. • Fresno, CA 93727 (559) 291-1650 • (800) 428-7139 • FAX (559) 348-9677 Revised 1-24...
ELITE SERIES ROCKY OILLESS COMPRESSOR INSTALLATION, USER AND SERVICE MANUAL This manual is for the installation and service of Tech West’s Rocky Series Oilless Compressors. CONTENTS Table of Contents Installation Information Installation Steps Operating, Storage, and Classifications Connection Diagram Post-Instatallation Safety Checks...
ELITE SERIES ROCKY OILLESS COMPRESSOR 1. ROCKY COMPRESSOR LOCATION REQUIREMENTS The Elite Series Rocky Compressor location should be level, accessible and well ventilated. DO NOT INSTALL THE COMPRESSOR IN A CONFINED SPACE, ATOP BUILDINGS, OR IN AREAS WITH MOISTURE. INSTALLATION IS REQUIRED TO BE PERFORMED BY QUALIFIED PERSONNEL. Electrical Line voltage must be within the limits of Figure 1 below.
2. INSTALLATION STEPS This dental compressor should only be installed by qualified personnel. Should any questions arise during the installation, call Tech West Technical Support between the hours of 7:00 a.m. to 4:00 p.m. (Pacific Standard Time). Place the compressor in a clean, dry, well ventilated area, on a solid, level surface. Consider sound level and insulate as needed.
ELITE SERIES ROCKY OILLESS COMPRESSOR 3. ENVIRONMENT REQUIREMENTS : Operating Indoor use at altitudes up to 6562 ft (2000m). Ambient temperatures 41° to 104°F (5° to 40°C). Supply voltage fluctuation of +/- 10% of nominal voltage. Storage and Transport: Temperature, 0° to 150°F (-40° to 65°C) Relative Humidity, 0 to 90%, non-condensing Atmosphere pressure range of 50kPA to 106kPA IEC 60601-1 Classification:...
ELITE SERIES ROCKY OILLESS COMPRESSOR 4. CONNECTIONS Figure 2 Electrical Connection to Dryer Purge disconnect and electrical panel Connection Air Out Connection to building supply line Alternate Air Connection to fresh air supply...
ELITE SERIES ROCKY OILLESS COMPRESSOR 5. SAFETY PRECAUTIONS Keep fingers, foreign objects and clothing free from rotating parts and do not touch hot surfaces. Never attempt to service an operating unit. Isolate unit from system pressure and relieve backpressure before servicing. Disconnect all power before servicing.
ELITE SERIES ROCKY OILLESS COMPRESSOR 7. GENERAL SERVICE INFORMATION For parts and service on Rocky series products contact the nearest authorized Tech West distributor. To expedite appropriate service, be prepared to provide the unit model number, identification number, and serial number found on the nameplate located on the front of the unit switch plate.
& repair. disconnected? CHECK FOR: Is there sufficient 1. Broken or loose Is there suffi- Install wire. voltage at motor cient voltage Tech West 2. Defective pressure terminals while at disconnect transformer. switch. box? motor tries to start? 3. Defective ON/OFF switch.
IMPORTANT SAFETY INFORMATION & WARNINGS *Installation Warnings Manufacturer recommends installation to be performed by qualified service personnel. See page 15 for a breakdown of gross weight by model. Manufacturer recommends using a forklift or pallet jack to move and set unit(s). FAILURE TO USE PROPER EQUIPMENT TO MOVE AND INSTALL UNIT(S) COULD RESULT IN INJURY.
WARRANTY INFORMATION Standard Warranty Period The Elite Series Rocky Oilless Compressors come with a standard 5 year or 3500 hour warranty that covers the motors. The standard warranty period on all other parts for the Elite Series Rocky Oilless Compressor is 2 years.
Need help?
Do you have a question about the ELITE ROCKY ACOR2D1 and is the answer not in the manual?
Questions and answers