Recording From The Radio - Philips Aw 7960 Instructions For Use Manual

CASSETTE RECORDER
Recording from the radio
• Set the MODE selector to RADIO.
- The RADIO indicator will lights up.
• Tune to the desired radio station (see'Radio
reception').
• Insert a blank cassette in deck 1.
• Press RECORD • to start recording.
- For brief interruptions, press PAUSE II. To resume
recording press PAUSE II again.
- A whistling sound occuring during AM radio
recordings can be suppressed by setting the BEAT
CUT switch to another positions.
• To stop recording, press STOP • OPEN M A.
Microphone & Karaoke recording
• Connect the microphone to the KARAOKE socket,
with the volume turned down to avoid noise
disturbance.
• Set the MODE selector to the desired position
(TAPE/RADIO OFF. CD/LINE IN or RADIO).
• Insert a blank cassette in deck 1.
• Press RECORD • to start recording.
- For brief interruptions, press PAUSE II. To resume
recording press PAUSE
II
again.
• To stop recording, press STOP • OPEN ■ A.
- If you want to monitor your microphone recording,
you can insert headphones in the ft socket.
Karaoke
• For recording karaoke, connect the microphone to the
KARAOKE socket, with the volume turned down to
avoid noise disturbance.
• Press both STOP • OPEN ■ A buttons and insert a
recorded tape into deck 2 and a suitable tape for
recording in deck 1.
• Press PAUSE II and then RECORD • on deck 1.
• To start recording, press PLAY ► on deck 2. PAUSE
lion deck 1 is then released.
• By pressing PAUSE
II
on deck 1, you can omit
undesired passages while deck 2 continues. Press
PAUSE
II
to resume recording.
• To stop recording karaoke, press both
STOP • OPEN ■ A buttons.
Recording from CD/LINE IN sources
• Connect the CD/LINE in sockets of the set with the
LINE OUT or REC OUT sockets of the other set.
• Set the mode selector to CD/LINE in.
The CD/LINE IN indicator lights up.
• Insert a blank cassette tape in the cassette holder.
• Press RECORD • to start recording.
• to stop recording, press STOP • OPEN
M
A.
- The CD/LINE IN indicator will go out.
Dubbing - Copying from deck 2 to 1
When copying, it is recommended to use fresh
batteries or to connect the set to the mains supply.
• Set the MODE selector to TAPE/RADIO OFF.
Do not move this selector during dubbing.
• Press HIGH SPEED DUBBING, unless you want to
record at normal speed. Do not press this Jbutton
during dubbing otherwise your recording will be
affected!
• Press both STOP • OPEN ■ A buttons and insert a
recorded tape into deck 2 and a suitable tape for
recording in deck 1.
• Press PAUSE ll and then RECORD • on deck 1.
• To start dubbing, press PLAY ► on deck 2. PAUSE 11
on deck 1 is then released.
• By pressing PAUSE II on deck 1, you can omit
undesired passages while deck 2 continues. Press
PAUSE II to resume dubbing.
• To stop dubbing, press both STOP • OPEN ■ A
buttons.
8